Up-and-down adjustment: For a left-hinge door, using a 1/ 4" allen wrench, turn the adjustment bolt clockwise to raise the door and counterclockwise to lower. Reverse directions for a right-hinge door. Side-to-side tilt adjustment: For a left-hinge door, using aģ/ 8" wrench, turn the adjustment bolt clockwise to raise the handle side of the door, and counterclockwise to lower the handle side. In-and-out adjustment: For a left-hinge door, using a 5/ 32" allen wrench, turn the adjustment bolt clockwise toīring the handle side of the door inward, and counterclockwise to move the handle side outward. To make adjustments, slightly loosening the two upper hinge bolts on the upper hinge plate using a 1/ 2" wrench. The doors of side-by-side models can also be adjusted up and down. The doors of side-by-side and over-and-under models can be adjusted in and out, and side to side tilt. IMPORTANT NOTE: For over-and-under and French door models, additional routing will be necessary to accommodate the lower hinge plate of the refrigerator. Verify the finished height before modifying panels. IMPORTANT NOTE: The height of the side panel will vary with the height of the grille. Routing will be necessary for the side panel to fit flush against the side of the unit. IMPORTANT NOTE: The use of side panels may change the width of the opening.Ī custom side panel must be a minimum of 24" (610) deep and 1/ 2" (13) thick. Stainless steel and white enamel side panels are also available from an authorized Sub-Zero dealer. For local dealer information, visit the find a showroom section of our website,. When installing a custom side panel, an accessory kit is required and is available through an authorized Sub-Zero dealer.
IMPORTANT NOTE: In some installations the subflooring or finished floor may necessitate angling the screws used to fasten the anti-tip brackets to the back wall.
IMPORTANT NOTE: For wood or concrete floor applications, if the #12 screws do not hit a wall stud or wall plate, use the #8 screws and #12 washers with the wall anchors. Use all anti-tip bracket hardware as instructed for wood or concrete floors. Failure to properly position the anti-tip brackets will prevent proper engagement. This depth will increase to 26 3/ 16" (665) for a flush inset installation based on 3/ 4" (19) thick panels. The two anti-tip brackets must be installed exactly 24" (610) from the front of the opening to the back of the brackets and a minimum of 4" (102) from the sides of the opening. To prevent the unit from tipping forward, the anti-tip brackets must be installed.
0 kommentar(er)
